Related Experiment Video
Updated: Dec 1, 2025

Generation and Coherent Control of Pulsed Quantum Frequency Combs
Published on: June 8, 2018
Coherent Interactions in One-Dimensional Topological Photonic Systems and Their Applications in All-Optical Logic
Yuhui Wang1, Wenjing Liu1, Zhurun Ji1
1Department of Materials Science and Engineering, University of Pennsylvania, Philadelphia, Pennsylvania 19104, United States.
Abstract:
Topological photonics has become an active subfield of photonics analogous to the electronic counterpart, and the bulk-edge correspondence leads to robust topologically protected interfacial states. However, a single-topological interface mode with fixed energy cannot be easily manipulated, hindering its applications in optical devices. Here, we study coupled-waveguide arrays mapped to a one-dimensional Su-Schrieffer-Heeger system with two coupled topological interfaces. This configuration greatly increases device versatility and tunability while keeping the confinement of coupled-interface modes inherited from the topological properties nearly intact. Theoretically predicted oscillations between coupled interfaces is experimentally observed. The spatial and energetic isolation of the coupled interface states from the bulk modes is experimentally observed and theoretically confirmed by calculating the degree of localization of the eigenstates, which is found to be comparable to a single-interface state. Finally, a proof-of-principle, all-optical logic circuit is fabricated based on coupled interfaces, demonstrating its potential in assembling on-chip topological optical devices.
Related Concept Videos
Second-Order Circuits
Input signals typically originate from voltage or current sources, with the output often representing voltage across the capacitor and/or current through the inductor. For example, in...
Bewley Lattice Diagram
First-Order Circuits
One common example of a first-order circuit is the RC (resistor-capacitor) circuit. These circuits are used in relaxation oscillators such as neon lamp oscillator circuits. When voltage is...
Convolution Properties I
The commutative property reveals that the input and the impulse response of an LTI (Linear Time-Invariant) system can be interchanged without affecting the output:

