RETRACTED: Non-Destructive Testing Mechanism for Pre-Stressed Steel Wire Using Acoustic Emission Monitoring

In this paper, the guided ultrasonic wave propagation characteristics in the axisymmetric pre-stressed viscoelastic waveguide for acoustic emission (AE) monitoring, using the semi-analytical finite element (SAFE) method, is studied broadly. For the numerical investigation, a single high-strength steel wire is considered. A comprehensive and in-depth study on the AE signal's propagation characteristics is carried out based on the SAFE method. Both undamped and damped waveguides are considered for attaining SAFE solutions and presented in a detailed manner. The SAFE method for an axisymmetric cross-section in cylindrical coordinates analyzes the two main influencing factors of steel wire in a practical scenario: Material damping and initial tension. For the effect of initial stress, the calculation shows that the initial tensile stress can increase and decrease the energy velocity and attenuation factor of most modal waves above the cut-off frequency, and the effect is linear. Some longitudinal wave modes in the high-frequency region show their potential for AE monitoring as these modes have a low attenuation factor and small external surface vibration. By considering various states of initial stress in a damped waveguide, the effect of pre-stress on the dispersion characteristics is understood in a better manner. A non-destructive testing (NDT) mechanism for pre-stressed steel wire using AE monitoring is proposed for the health monitoring of structures.