Propositure of maximum permissible limits for environmental assessment and classification of materials stabilized by...

In the present work, oil sludge was subjected to the process of stabilization by solidification, the objective was to indicate maximum permissible limits of chemical demand for oxygen and oils and greases to evaluate the resulting material. A factorial design was used with the addition of three repetitions at the central point, to evaluate the performance of different percentage of residue and different curing times. The factors adopted were the percentage of oil sludge and the curing time. This material was evaluated using contaminants immobilization tests. From the leached and solubilized liquid, the concentration of the contaminants was determined and the environmental assessment was also carried out through the analysis of chemical demand for oxygen and oils and greases. One of the contributions of this work was to propose the maximum allowable limit for chemical oxygen demand, which is 1,000 (one thousand) milligrams per litre and, for oil and grease content, 100 (one hundred) milligrams per litre, both for the leaching test. For the solubilization test, 10 (ten) milligrams per litre were proposed for chemical oxygen demand and 1 (one) milligrams per litre for the oil and grease content. It was observed that the best results are obtained, when lower values of percentage of oil sludge were used and longer cure time. This work allows to affirm that the proposal of limits of environmental evaluation contributes to assure an adequate disposition and use of the cement matrix, that is the final product of the oily residue stabilized by solidification.