Theoretical analysis of superadiabatic combustion for non-stationary filtration combustion by excess enthalpy

Junrui Shi1, Mingming Mao1, Yongqi Liu1

  • 1School of Transportation and Vehicle Engineering, Shandong University of Technology, Zibo, 255049 Shandong, People's Republic of China.

Royal Society Open Science
|November 18, 2020
PubMed

Related Concept Videos

Enthalpy and Heat of Reaction02:12

Enthalpy and Heat of Reaction

Combustion, commonly known as burning, is a reaction in which a substance reacts with an oxidizing agent, which in most cases is molecular oxygen, to liberate energy in the form of heat, light, or sound. The heat of combustion is also known as the enthalpy of combustion. The energy released when one mole of a substance undergoes complete combustion at constant pressure is called molar heat of combustion. Combustion reactions are exothermic; that is, they release energy, and their ΔH sign...
9.3K
Work Done in an Adiabatic Process01:20

Work Done in an Adiabatic Process

Consider the adiabatic compression of an ideal gas in the cylinder of an automobile diesel engine. The gasoline vapor is injected into the cylinder of an automobile engine when the piston is in its expanded position. The temperature, pressure, and volume of the resulting gas-air mixture are 20 °C, 1.00 x 105 N/m2, and 240 cm3 , respectively. The mixture is then compressed adiabatically to a volume of 40 cm3. Note that, in the actual operation of an automobile engine, the compression is not...
3.9K
Adiabatic Processes for an Ideal Gas01:18

Adiabatic Processes for an Ideal Gas

When an ideal gas is compressed adiabatically, that is, without adding heat, work is done on it, and its temperature increases. In an adiabatic expansion, the gas does work, and its temperature drops. Adiabatic compressions actually occur in the cylinders of a car, where the compressions of the gas-air mixture take place so quickly that there is no time for the mixture to exchange heat with its environment. Nevertheless, because work is done on the mixture during the compression, its...
3.7K
The Carnot Cycle01:30

The Carnot Cycle

Converting work to heat is an irreversible process, and the purpose of a heat engine is to reverse the effect partially. Heat engines aim to increase the efficiency of the reversal, that is, maximize the work retrieved from heat. If the efficiency of a heat engine were 100%, it would imply reversing the process completely without introducing any other effect. Thus, it would violate the second law of thermodynamics.
What could be the theoretical limit to the efficiency of a heat engine? The...
3.7K
Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
52.9K
Enthalpies of Reaction03:33

Enthalpies of Reaction

Hess’s law can be used to determine the enthalpy change of any reaction if the corresponding enthalpies of formation of the reactants and products are available. The main reaction may be divided into stepwise reactions : (i) decompositions of the reactants into their component elements, for which the enthalpy changes are proportional to the negative of the enthalpies of formation of the reactants, −ΔHf°(reactants), followed by (ii) re-combinations of the elements (obtained in step 1) to...
38.1K