Risk Factor Analysis of Facet Fusion Following Cervical Lateral Mass Screw Fixation with a Minimum 1-Year Follow-up: Assessment of Maximal Insertional Screw Torque and Incidence of Loosening

Posterior stabilization is a common surgical procedure, which aims for rigid stabilization by facet fusion. Facet non-union has a potential risk of the screw loosening and malalignment. Although some authors have reported the influencing factors about screw loosening in the lumbar spine, there are few reports about the risk factor contributing to the facet non-union in the cervical spine. In all, 22 patients (78 facets and 122 screws) with degenerative cervical kyphosis or spondylolisthesis who underwent decompression and lateral mass screw (LMS) fixation were analyzed. Age, gender, smoking, bone mineral density (BMD), the degree of facet decortication with bone packing, and screw loosening were investigated as risk factors contributing to the facet non-union at each segmental fused level. Facet fusion rate was 85.9% (67/78 facets) and the incidence of loosening was 4.9% (6/122 screws, 4 patients). Insufficient facet decortication with bone packing is a significant risk factor of facet non-union (p <0.05, odds ratio: 26.5). All six loosened screws were associated with bony non-union of the facet and were located in the uppermost or lowermost vertebrae. Comparing loosened screws and stable screws, the average maximal insertional screw torque (MIT) was 9.8 cNm and 39.5 cNm, respectively (p <0.05). Additionally, the length of the stable screws was significantly longer versus the loosened screws (p <0.05). Lower MIT and shorter screw length located near the ends of the lateral mass may predict loosening, which can lead to facet non-union. Sufficient facet decortication with bone packing is one of the important factors contributing to the facet fusion.