Related Experiment Video
Updated: Nov 28, 2025

Transmission of Multiple Signals through an Optical Fiber Using Wavefront Shaping
Published on: March 20, 2017
Hybrid wideband multipath self-interference cancellation with an LMS pre-adaptive filter for in-band full-duplex OFDM
Abstract:
A wideband multipath self-interference cancellation (SIC) system employing both dual-drive Mach-Zehnder modulator-based analog SIC and least mean square (LMS) algorithm-based pre-adaptive filter digital SIC is proposed and demonstrated for the cancellation of multipath self-interference (SI) and facilitation of in-band full-duplex (IBFD) orthogonal frequency-division multiplexing (OFDM) signal transmission. The multipath effect is an unavoidable challenge in SIC due to the dynamic and unpredictable properties in each path, as well as the need for separate matching components for compensating for each path. In this Letter, an LMS algorithm-based adaptive filter is used as a pre-equalizer to adapt and generate the matching signal to the closest approximate of the multipath SI signal. The adaptation is based on the minimization of the error signal generated from the matching signal and multipath SI signal in the LMS algorithm. With the introduction of the LMS adaptive filter to the analog SIC, an additional 9 dB cancellation improvement is obtained, resulting in a total of 32 dB cancellation depth over a cancellation bandwidth of 2.7 GHz at a center frequency of 1.65 GHz. To the best of our knowledge, the achieved performance is by far the widest cancellation bandwidth in a multipath SIC system, which is essential in a large bandwidth and high data rate transmission system. With the help of the proposed LMS adaptive filter digital SIC assisted analog SIC located at the remote node, power-efficient IBFD transmission of an OFDM signal through a 25 km fiber is experimentally demonstrated with a 6 dB bit error rate and 8% error vector magnitude improvements.
Related Concept Videos
Bandpass Sampling
A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2....
Design Example
Active Filters
Passive Filters
Low-Pass Filters
Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff...
Parallel Resonance
Reconstruction of Signal using Interpolation

