A MIP-based low-cost electrochemical sensor for 2-furaldehyde detection in beverages

There is an increasing interest in determining the concentration of furanic compounds naturally formed in food aqueous matrices, by in situ, fast and low-cost methods. A sensor presenting such characteristics is here proposed, and characterized. It is based on a molecularly imprinted polymer (MIP) as a receptor with electrochemical transduction on a screen printed cell (SPC). The molecularly imprinted polymer has been developed for a particular furanic derivative, 2-furaldehyde (2-FAL). The detection bases on the reduction of 2-FAL selectively adsorbed on the polymer layer in contact with the working electrode. The polymer layer is simply formed by in situ polymerization, directly over the SPC and it was characterized by IR, SEM and electrochemical methods. Even if based on an easy and fast preparation procedure, the layer sufficiently adheres to the cell surface giving a reusable sensor. Square wave voltammetry (SWV) was applied as the signal acquisition method. The sensor performance in aqueous solution (NaCl 0.1 M) was tested, obtaining that the dose-response curve is fitted by the Langmuir adsorption isotherm. The sensitivity, and so the limit of detection, were noticeably improved by a chemometric approach based on the Design of experiment method. (optimized conditions: E_step = 0.03 V, E_pulse = 0.066 V, f = 31 s^-1). In water solution at pH around neutrality the dynamic range was from about 50 μM to 20 mM. Similar results were obtained for a white wine containing 12% ethanol, which has been considered as a typical example of beverage possibly containing furhaldehydes. The higher limit of quantification can be modulated by the amount of MIP deposited, while the lower detection limit by the conditions of the electrochemical measurement.