Related Experiment Video
Updated: Nov 27, 2025

Author Spotlight: Standardizing the Development of Amine-Based Silica Composites as CO2 Adsorbents for Direct Air Capture
Published on: September 29, 2023
The Effect of Adhesive Additives on Silica Gel Water Sorption Properties
Karol Sztekler1, Wojciech Kalawa1, Agata Mlonka-Medrala1
1Faculty of Energy and Fuels, AGH University of Science and Technology, A. Mickiewicza Av.30, 30-059 Krakow, Poland.
Abstract:
Adsorption chillers are characterized by low electricity consumption, lack of moving parts, and high reliability. The disadvantage of these chillers is their large weight due to low adsorbent sorption capacity. Therefore, the attention is turned to finding a sorbent with a high water sorption capacity and enhanced thermal conductivity to increase chiller efficiency. The article discusses the impact of selected adhesives used for the production of an adsorption bed in order to improve heat exchange on its surface. Experiments with silica gel with three commercial types of glue on metal plates representing heat exchanger were performed. The structure of samples was observed under a microscope to determine the coverage of adsorbent by glue. To determine the kinetics of the free adsorption, the amounts of moisture adsorbed and the desorption dynamics the prepared samples of coated bed on metal plates were moisturized and dried in a moisture analyzer. Samples made of silica gel mixed with the adhesive 2-hydroxyethyl cellulose, show high adsorption capacity, low dynamic adsorption, and medium dynamic desorption. Samples containing adhesive poly(vinyl alcohol) adsorb less moisture, but free adsorption and desorption were more dynamic. Samples containing the adhesive hydroxyethyl cellulose show lower moisture capacity, relatively dynamic adsorption, and lower dynamic desorption.
Related Concept Videos
Silica Gel Column Chromatography: Overview
Polar components tend to bind strongly to the silica gel, causing them to move slowly through the column. In contrast, nonpolar compounds...
Adhesion
Capillary action is a result of water’s adhesive tendencies. When a narrow...
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Analyte Adsorption and Distribution
Superplasticizers
Enthalpy of Solution

