Process optimization of twin-screw melt granulation of fenofibrate using design of experiment (DoE)

The purpose of this study was to optimize the melt granulation process of fenofibrate using twin-screw granulator. Initial screening was performed to select the excipients required for melt granulation process. A 3 × 3 factorial design was used to optimize the processing conditions using the % drug loading (X₁) and screw speed (X₂) as the independent parameters and granule friability (Y₁) % yield (Y₂) as the dependent parameters. The effect of the independent parameters on the dependent parameters was determined using response surface plots and contour plots. A linear relationship was observed between % drug loading (X₁) and % friability (Y₁) and a quadratic relationship was observed between the independent parameters (X₁ and X₂) and % yield (Y₂). The processing conditions for optimum granules were determined using numerical and graphical optimization and it was found that 15% drug loading at 50 rpm results in maximum % yield of 82.38% and minimum friability of 7.88%. The solid-state characterization of the optimized granules showed that the drug turned from crystalline state to amorphous state during melt granulation process. The optimized granules were compressed into tablets using Purolite® as the super disintegrating agent. The optimized formulation showed >85% drug release in 0.75% SLS solution within 60 min.