Can changes in midsole bending stiffness of shoes affect the onset of joint work redistribution during a prolonged
Sasa Cigoja1, Jared R Fletcher2, Benno M Nigg1
1Human Performance Laboratory, Faculty of Kinesiology, University of Calgary, Calgary, AB T2N 1N4, Canada.
Purpose:
This study aimed to investigate if changing the midsole bending stiffness of athletic footwear can affect the onset of lower limb joint work redistribution during a prolonged run.
Methods:
Fifteen trained male runners (10-km time of <44 min) performed 10-km runs at 90% of their individual speed at lactate threshold (i.e., when change in lactate exceeded 1 mmol/L during an incremental running test) in a control and stiff shoe condition on 2 occasions. Lower limb joint kinematics and kinetics were measured using a motion capture system and a force-instrumented treadmill. Data were acquired every 500 m.
Results:
Prolonged running resulted in a redistribution of positive joint work from distal to proximal joints in both shoe conditions. Compared to the beginning of the run, less positive work was performed at the ankle (approximately 9%; p ≤ 0.001) and more positive work was performed at the knee joint (approximately 17%; p ≤ 0.001) at the end of the run. When running in the stiff shoe condition, the onset of joint work redistribution at the ankle and knee joints occurred at a later point during the run.
Conclusion:
A delayed onset of joint work redistribution in the stiff condition may result in less activated muscle volume, because ankle plantar flexor muscles have shorter muscles fascicles and smaller cross-sectional areas compared to knee extensor muscles. Less active muscle volume could be related to previously reported decreases in metabolic cost when running in stiff footwear. These results contribute to the notion that footwear with increased stiffness likely results in reductions in metabolic cost by delaying joint work redistribution from distal to proximal joints.
Related Concept Videos
Residual Stresses in Bending
Bending of Members Made of Several Materials
Hooke's Law determines stress in each material, stating that stress is proportional to strain but varies due to each material's...
Members Made of Elastoplastic Material
As the bending moment...
Flexural Stress
Hooke's Law states that within the material's elastic limits, stress is directly proportional to strain. In a member experiencing a bending moment, the strain at any point is relative to its distance...
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Plastic Behavior


