Related Experiment Video
Updated: Nov 23, 2025
A Novel Method to Determine the Longitudinal Antibacterial Activity of Drug-Eluting Materials
Published on: March 3, 2023
In vitro elution characteristics of gentamicin-impregnated Polymethylmethacrylate: premixed with a second powder vs.
Wongthawat Liawrungrueang1, Suwipa Ungphaiboon2, Arnurai Jitsurong3
1Department of Orthopedics, Faculty of Medicine, Prince of Songkla University, Hat Yai, Songkhla, 90110, Thailand.
Background:
Antibiotic-loaded bone cement, or antibiotic-impregnated polymethylmethacrylate (PMMA), were developed to prevent and treat bone and joint infections. Gentamicin is an antibiotic that is commonly used in combination with PMMA; however, gentamicin powder is hard to obtain in many countries. This study aimed to evaluate the elution characteristics of gentamicin-impregnated PMMA made with lyophilized liquid gentamicin, compared with PMMA; which is made from commercial gentamicin powder.
Methods:
The experimental sample was divided into 2 groups: the gentamicin power group (PG-PMMA) and the lyophilized liquid gentamicin group (LG-PMMA). Ten cement spacers were prepared in each group. These were produced by mixing gentamicin powder, or lyophilized liquid gentamicin, with a powder polymer before adding the liquid monomer (2 g of gentamicin and 40 g of PMMA). The volume and surface area of the antibiotic-impregnated cement spacers were 50 cm3 and 110 cm2, respectively. Each spacer was immersed in phosphate-buffered saline, which was changed daily under sterile conditions. The solutions were collected to measure the level of gentamicin using the enzyme multiplied immunoassay technique (EMIT), at days 1, 2, 3, 4, 5, 6, 7, 14, 21, 28, 35 and 42.
Results:
The collections from both groups had high concentrations of gentamicin on day 1 (113.63 ± 23.42 mg/dL in LG-PMMA and 61.7 ±8.37 mg/dL in PG-PMMA), but experienced a continuous decrease over time. The PMMA spacers from both groups could release gentamicin for up to 6 weeks (3.28 ± 1.17 mg/dL in LG-PMMA and 1.21 ± 0.28 mg/dL in PG-PMMA). However, there were significantly higher levels of gentamicin concentrations in the LG-PMMA group compared to the PG-PMMA group at all time points (P< 0.05).
Conclusion:
Gentamicin-impregnated PMMA made with lyophilized liquid gentamicin had approximately a two times higher rate of antibiotic elution in preliminary in vitro studies, as compared with PMMA made with premixed gentamicin powder.
More Related Videos
11:32Characteristics of Precipitation-formed Polyethylene Glycol Microgels Are Controlled by Molecular Weight of Reactants
Published on: December 23, 2013
10:36Gelatin Methacryloyl Granular Hydrogel Scaffolds: High-throughput Microgel Fabrication, Lyophilization, Chemical Assembly, and 3D Bioprinting
Published on: December 9, 2022
Related Concept Videos
01:17In Vitro Drug Dissolution: Alternative Methods
01:15Determination of Multiple Dosing Parameters: Steady-State, Minimum and Maximum Concentrations
01:21Factors Affecting Dissolution: Polymorphism, Amorphism and Pseudopolymorphism
Some polymorphic crystals possess lower aqueous solubility than their amorphous counterparts, leading to incomplete absorption. For instance, the oral suspension of Chloramphenicol, which...