Related Experiment Video

Updated: Nov 20, 2025

In Situ Visualization of the Phase Behavior of Oil Samples Under Refinery Process Conditions
11:20

In Situ Visualization of the Phase Behavior of Oil Samples Under Refinery Process Conditions

Published on: February 21, 2017

6.9K

Energy intensity convergence in Iranian provinces: evidence from energy carriers' consumption intensity

Zahra Dehghan Shabani1, Rouhollah Shahnazi2

  • 1Department of Economics, Shiraz University, Shiraz, Iran. zdehghan@shirazu.ac.ir.

Environmental Science and Pollution Research International
|January 26, 2021
PubMed

Keywords:
ConvergenceEnergy intensityIranMarkov chain method

More Related Videos

Measuring Liver Mitochondrial Oxygen Consumption and Proton Leak Kinetics to Estimate Mitochondrial Respiration in Holstein Dairy Cattle08:29

Measuring Liver Mitochondrial Oxygen Consumption and Proton Leak Kinetics to Estimate Mitochondrial Respiration in Holstein Dairy Cattle

Published on: November 30, 2018

11.6K
Photoelectron Imaging of Anions Illustrated by 310 Nm Detachment of F−06:53

Photoelectron Imaging of Anions Illustrated by 310 Nm Detachment of F−

Published on: July 27, 2018

9.0K

Related Concept Videos

IR Spectrum Peak Intensity: Amount of IR-Active Bonds00:55

IR Spectrum Peak Intensity: Amount of IR-Active Bonds

When infrared radiation is passed through a molecule, absorption occurs if the molecule's vibration leads to a substantial change in its bond dipole moment. Transitions between vibrational energy levels, typically corresponding to infrared frequencies (4000–400 cm−1), allow absorption if the vibration significantly alters the dipole moment, making the molecule infrared active. The molecular bonds have different stretching and bending vibrations, resulting in various peaks with...
832
Strain-Energy Density01:20

Strain-Energy Density

Understanding the strain energy density in materials under axial load is crucial for evaluating their mechanical behavior and durability. When a rod is subjected to such a load, it elongates and stores energy, known as strain energy, as potential energy within the material. This energy is measured in terms of energy per unit volume.
In the elastic region of a material, the relationship between the stress and the strain is linear and follows Hooke's Law. The strain energy density in this region...
664
Energy Diagrams - I01:14

Energy Diagrams - I

The dynamics of a mechanical system can be easily understood by interpreting a potential energy diagram. Since energy is a scalar quantity, the interpretation of the dynamics of the system becomes even simpler.
Take the example of a skater on a parabolic ramp. The potential energy at different points along the ramp will be proportional to the height of the ramp, which varies quadratically with the horizontal position on the ramp. As the skater moves down the ramp from the highest position,...
5.4K
Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes02:14

Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes

The low reactivity in alkanes can be attributed to the non-polar nature of C–C and C–H σ bonds. Alkanes, therefore, were  initially termed as “paraffins,” derived from the Latin words: parum, meaning “too little,” and affinis, meaning “affinity.”
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified...
7.4K
Energy Basics02:27

Energy Basics

Chemical reactions, such as those that occur when you light a match, involve changes in energy as well as matter.
45.4K
Energy Diagrams - II01:10

Energy Diagrams - II

Energy diagrams are important to understand the dynamics of a system. The topology of an energy diagram helps illustrate the equilibrium points of the system.
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The...
9.8K