Related Experiment Video
Updated: Nov 18, 2025

Fabrication of Microscope Stage for Vertical Observation with Temperature Control Function
Published on: July 31, 2019
Variation of rooftop thermal environment with roof typology: a field experiment in Kitakyushu, Japan
Gaochuan Zhang1, Qian Wu1, Bao-Jie He2,3
1School of Civil Engineering and Architecture, Zhejiang University of Science & Technology, Hangzhou City, 310023, China.
Abstract:
While urban open spaces have been shrinking with the rapid urbanization, rooftop space use is an alternative solution to such problems. Rooftop thermal environment is a critical consideration under global warming and local warming. Although there have been studies on rooftop thermal environment, variation of rooftop thermal environment with roof typology has not been fully revealed to support rooftop space design. To fill this gap, a field experiment was conducted over green roof (GR), wooden roof (WR), and shaded roof (SR) in a temperate city of Kitakyushu, Japan. Environmental parameters such as solar radiation, air temperature, and relative humidity at different heights of these three roofs were recorded, to understand rooftop thermal environment and daily heat stress variation with rooftop types and the height above roof surface. The results indicate that WR had the highest diurnal near-surface temperature and the worst heat stress, where the near-surface heat stress could even reach the danger level. GR exhibited the lowest diurnal near-surface temperature and heat stress, where the heat stress was only under caution and almost safe condition. SR exhibited the lowest diurnal 1-m temperature and SR had the weakest heat stress, indicating the significance of installing shading devices for rooftop thermal environment improvement and heat stress alleviation. GR exhibited excellent performance in reducing air temperature and heat stress at the pedestrian level, where its worst heat stress was only in caution condition. Compared with that at 1-m height, moreover, 1-cm temperature and heat stress of WR and SR were generally higher, indicating that people may undergo worse heat stress when kneeling or sitting compared with upright activities. Moreover, GR suppressed near-surface heat stress due to its excellent cooling performance.
Related Concept Videos
Thermal Insulation in Masonry Walls
External insulation can be applied using an Exterior Insulation and Finish System (EIFS), which involves affixing panels of plastic foam to the wall and covering them with a polymeric stucco reinforced with glass fiber mesh....
Masonry in Cold and Hot Weather Conditions
Other key practices include keeping masonry units...
Design Example: Sustainability in Concrete Building
There are multiple approaches to achieve sustainability in a commercial concrete building. For instance, construct a concrete parking area under the building, utilizing pervious concrete paver blocks in open areas to facilitate rainwater collection through an underground...
Insulation Coordination
Frost Resistant Concrete
Introducing microscopic air bubbles into the concrete mix through air entrainment creates small voids that accommodate ice expansion, thereby reducing internal pressures and preventing cracking. The optimal amount of...
Temperature Measurement Sites
Oral: When assessing oral temperature, the thermometer tip should be placed under the tongue in the posterior sublingual pocket. It offers accurate readings and can be...

