Effectiveness of Commercial Software-Enhanced Image Artifact Reduction Software
Tyler Phaneuf1, Anil Kishen1, Massieh Moayedi1
1Faculty of Dentistry, The University of Toronto, Toronto, Ontario, Canada.
Introduction:
Artifact reduction (AR) software has been incorporated into some cone-beam computed tomographic (CBCT) systems to reduce the severity of beam hardening (BH) artifacts and improve image quality. This study quantifies BH artifact and evaluates the effectiveness of AR in 2 CBCT systems.
Methods:
Palatal roots of Dent-Alike (Dentsply Sirona, Tulsa, OK) teeth were prepared and root filled with gutta-percha and EndoSequence BC Sealer (Brasseler, Savannah, GA). Six teeth were imaged with and without AR software using the ProMax3D (Planmeca Oy, Helsinki, Finland) and the Pax-i3D (Vatech, Hwaseong-si, South Korea) systems. FSL (FMRIB, Oxford, UK) software was used to quantify the light and dark components of the BH artifact along the tooth root using a specific region of interest approach and an image-wide analysis approach. Statistical analysis was performed using paired t tests and corrected for multiple comparisons with cluster mass correction using a nonparametric statistical analysis to evaluate the differences in the artifact volumes and areas with and without AR.
Results:
A significant reduction in the light artifact was observed with the Planmeca system (P < .05), but no significant differences were observed for either the light or dark artifacts with the Vatech system when AR was applied. There were also significant reductions in the volumes of light and dark artifacts along the entire root length when the AR was applied with the Planmeca system (cluster mass P < .05), but no significant differences were observed with the Vatech system.
Conclusions:
Proprietary AR software is not equally effective in reducing the light and/or dark components of CBCT BH artifacts.
