Related Experiment Video
Updated: Nov 18, 2025
Measuring the Complete-arch Distortion of an Optical Dental Impression
Published on: May 30, 2019
Comparative Analysis of Marginal Accuracy of Complete Crowns Fabricated by Using Ringless and Metal Ring Investment
Nikki Saini1, Sandeep Kumar2, Rajnish Aggarwal2
1Department of Prosthodontics, Surendera Dental College and Research Institute, Sri Ganganagar, Rajasthan, India, Phone: +91 9530204146,
Aim:
To compare the vertical margin accuracy of lost wax castings produced by the conventional casting technique with all metal (WIRONIUM®) and PFM alloy (WIRON®99) using a metal ring and ringless system.
Materials And Methods:
A brass die assembly was used to fabricate standardized wax pattern crowns. A total of 100 wax patterns were made with both ringless and metal ring investment systems. Wax patterns were readapted and refined on the master die and divided into two groups, namely, group I and group II with 50 wax patterns in each group. Group I (ringless system) and group II (metal ring system) were further divided into subgroups having a sample size of 25 in each group. Each coping was invested and cast individually. The marginal discrepancy between the metal die and the castings were measured by a stereomicroscope and AutoCAD software 2013. Measurement was made on the facial area of the metal die.
Results:
The resultant casts obtained from different casting systems show statistically significant difference found between the marginal discrepancies using metal ring and ringless castings system, and statistically nonsignificant difference was found between the marginal discrepancies using all metal alloy (WIRONIUM®) and PFM alloy (WIRON®99) within the same group.
Conclusion:
The marginal discrepancy for castings made with ringless casting system was less when compared to metal ring casting system, and there was no difference in marginal discrepancy when compared to all metal alloy (WIRONIUM®) and PFM alloy (WIRON®99) within the same group.
Clinical Significance:
Marginal fit is influenced by several factors including type of crown, tooth preparation geometry, dimensional accuracy of impression materials, factors related to dental casting, type of cement, luting pressure, duration of cementation, and use of occlusal vents or die spacers.
