Related Experiment Video
Updated: Nov 17, 2025

Standard Test Method ASTM D 7998-19 for the Cohesive Strength Development of Wood Adhesives
Published on: May 17, 2020
Bending Strength of Wood Treated with Propolis Extract and Silicon Compounds
Magdalena Woźniak1, Przemysław Mania2, Edward Roszyk2
1Department of Chemistry, Faculty of Forestry and Wood Technology, Poznań University of Life Sciences, 60625 Poznań, Poland.
Abstract:
The modification of wood and its treatment with various preservatives may affect its mechanical properties, hence the knowledge of the character changes in wood caused by impregnation is of great importance. Therefore, the aim of the research was to determine the effect of impregnation, with the propolis-silane preparation (EEP-MPTMOS/TEOS) consisting of the propolis extract (EEP) and silicon compounds: 3-(trimethoxysilyl)propyl methacrylate (MPTMOS) and tetraethoxysilane (TEOS), on the bending strength of treated wood. Moreover, in the study wood treated with components of the propolis-silane formulation was used, namely 70% ethanol, the propolis extract, and silanes (MPTMOS/TEOS). In order to determine whether the impregnation of wood affects its long-term bending, creep tests were performed depending on the humidity. The impregnation of wood with the propolis extract and the propolis-silane preparation (EEP-MPTMOS/TEOS) contributed to the increase in modulus of rapture and work to maximum load values compared to the untreated wood. In dry wood condition, the wood treated with EEP and EEP-MPTMOS/TEOS was characterized by lower modulus of elasticity values than the control samples. In turn, in wet wood condition, wood treated with the propolis-silane preparation showed an increase in the MOE value. Moreover, the impregnation of wood had an influence on the wood creep process under bending loads. The treated wood was characterized by higher relative creep compliance than the untreated wood. The exception was the wood impregnated with EEP-MPTMOS/TEOS, which showed comparable relative creep compliance to the control samples. The presented results indicate that wood treated with a bio-friendly preparation based on propolis and silicon compounds can be used in various application and also in variable humidity conditions.
Related Concept Videos
Structural Properties and Dimensions of Lumber
The strength characteristics of...
Bending of Members Made of Several Materials
Hooke's Law determines stress in each material, stating that stress is proportional to strain but varies due to each material's...
Wood Products
Glue-laminated wood, often referred to as glulam, combines multiple smaller pieces of dimensional lumber using adhesives to form a single, larger piece. Cross-laminated timber consists...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Design of Prismatic Beams for Bending
Bending
In pure bending, the bending stress in a beam is calculated based on the bending moment and...

