Related Experiment Video

Updated: Nov 17, 2025

Design and Application of a Fault Detection Method Based on Adaptive Filters and Rotational Speed Estimation for an Electro-Hydrostatic Actuator
06:45

Design and Application of a Fault Detection Method Based on Adaptive Filters and Rotational Speed Estimation for an Electro-Hydrostatic Actuator

Published on: October 28, 2022

2.0K

Prediction of human error probability during the hydrocarbon road tanker loading operation using a hybrid technique

Fakhradin Ghasemi1, Arash Ghasemi2, Omid Kalatpour3

  • 1Department of Ergonomics and Occupational Health and Safety Research Center, School of Public Health, Hamadan University of Medical Sciences, Iran.

International Journal of Occupational Safety and Ergonomics : JOSE
|February 17, 2021
PubMed

Keywords:
accident preventionerrorhuman factorsperformance

More Related Videos

Author Spotlight: Addressing Technical and Subjective Challenges in Measuring Classroom Attention06:37

Author Spotlight: Addressing Technical and Subjective Challenges in Measuring Classroom Attention

Published on: December 15, 2023

4.8K

Related Concept Videos

Hazard Rate01:11

Hazard Rate

The hazard rate, also known as the hazard function or failure rate, is a statistical measure used to describe the instantaneous rate at which an event occurs, given that the event has not yet happened. From a probabilistic perspective, it represents the likelihood that a subject will experience the event in a very small time interval, conditional on surviving up to the beginning of that interval. In terms of frequency, the hazard rate can be viewed as the ratio of the number of events to the...
266
Determination of Expected Frequency01:08

Determination of Expected Frequency

Suppose one wants to test independence between the two variables of a contingency table. The values in the table constitute the observed frequencies of the dataset. But how does one determine the expected frequency of the dataset? One of the important assumptions is that the two variables are independent, which means the variables do not influence each other. For independent variables, the statistical probability of any event involving both variables is calculated by multiplying the individual...
2.4K
Stereotype Content Model02:16

Stereotype Content Model

The Stereotype Content Model (SCM) was first proposed by Susan Fiske and her colleagues (Fiske, Cuddy, Glick & Xu, 2002; see also Fiske, 2012 and Fiske, 2017). The SCM specifies that when someone encounters a new group, they will stereotype them based on two metrics: warmth—or that group’s perceived intent, and how likely they are to provide help or inflict harm—and competence—or their ability to carry out that objective. Depending on the warmth-competence...
15.1K
Propagation of Uncertainty from Systematic Error01:10

Propagation of Uncertainty from Systematic Error

The atomic mass of an element varies due to the relative ratio of its isotopes. A sample's relative proportion of oxygen isotopes influences its average atomic mass. For instance, if we were to measure the atomic mass of oxygen from a sample, the mass would be a weighted average of the isotopic masses of oxygen in that sample. Since a single sample is not likely to perfectly reflect the true atomic mass of oxygen for all the molecules of oxygen on Earth, the mass we obtain from this...
1.1K
Distributed Loads: Problem Solving01:21

Distributed Loads: Problem Solving

Beams are structural elements commonly employed in engineering applications requiring different load-carrying capacities. The first step in analyzing a beam under a distributed load is to simplify the problem by dividing the load into smaller regions, which allows one to consider each region separately and calculate the magnitude of the equivalent resultant load acting on each portion of the beam. The magnitude of the equivalent resultant load for each region can be determined by calculating...
908
Probability Histograms01:17

Probability Histograms

A probability histogram is a visual representation of a probability distribution. Similar a typical histogram, the probability histogram consists of contiguous (adjoining) boxes. It has both a horizontal axis and a vertical axis. The horizontal axis is labeled with what the data represents. The vertical axis is labeled with probability. Each rectangular bar in the histogram is 1 unit wide, which suggests that the area under each bar equals the probability, P(x), where x is 1, 2, 3, and so on.
12.8K