Development of a Cost-Effective Surgical Headlight Using Consumer Light Emitting Diode Lighting and 3D Printing

Need. Battery-powered Light Emitting Diode (LED) surgical headlights are necessary for improved intraoperative illumination but may be costly. Technical Solution. The objective of this study was to develop a low-cost surgical headlight using a consumer-grade LED headlight and 3D-printed mount. Proof of Concept. Eighteen surgical residents performed simulation exercises that mimicked suturing in the oral cavity using both a custom prototype headlight and a commercial surgical headlight. The time required to complete the task with each headlight was recorded along with an exit survey. A second device was created based on the critiques of the first device and was tested by ten additional surgical trainees. Surgical residents completed the simulation task in 27 ± 8.6 seconds and 21 ± 5.6 seconds with the commercially available headlight and first prototype, respectively. In the second experiment, the simulation task was completed in 23 ± 11.1 and 23 ± 12.2 seconds with the commercially available headlight and second device, respectively. Survey results showed an overall positive consensus, with critiques about headband security, suggestions for smaller LED chassis, and a more robust mounting bracket. Some preferred the prototype headlight due to the wider field of illumination compared to the commercially available unit (ie, beam spread/beam angle). Next Steps. Future adjustments are required to optimize the location of the headlight and the battery to modify the weight distribution of the device. Conclusion. These findings demonstrate that our prototype models are viable alternatives to conventional surgical headlights and warrant continued optimization for broader adoption by surgeons and trainees for whom higher-cost alternatives are not an option.