Related Experiment Video
Updated: Nov 15, 2025

Electrochemically and Bioelectrochemically Induced Ammonium Recovery
Published on: January 22, 2015
Exergy study of amine regeneration unit using diethanolamine in a refinery plant: A real start-up plant
Ahmed Y Ibrahim1, Fatma H Ashour1, Mamdouh A Gadalla2,3
1Department of Chemical Engineering, Cairo University, Giza 12613, Egypt.
Abstract:
Refinery plants use diethanolamine (DEA) solutions for gas sweetening. The role of DEA is to absorb H2S from sour gas. Amine Regeneration Units (ARU) are used to regenerate the rich Amine with H2S from refinery units to Lean Amine. An ARU unit of a Middle Eastern refinery that began official production in 2020 was simulated using Aspen HYSYS V.11, and an exergy study was conducted on different equipment. Whereas energy is transformed from one form to another, the exergy is destroyed in an irreversible process. The total exergy was equal to the physical and chemical exergy. The physical exergy was calculated using HYSYS, and the chemical exergy was calculated using a series of equations embedded in Excel. The DEA concentration used was 25 wt%. The exergy destruction rates, destruction efficiency, and percentage share of destruction of each piece of equipment were calculated. The regenerator exhibited the highest destruction rate of 13459.73 kW, and a percentage share of 79.61% of the total destruction. The overall exergy efficiency was 99.7%. The DEA concentration decreased from 25% to 20% as a result of system losses during start-up. Therefore, a case study was conducted to test the effect of this decrease in the H2S concentration in the sweet gas, and no effect was observed. An exergy study was conducted using an DEA of 20%. The distribution of the equipment destruction did not change. The total destruction loss increased by 2057.08 kW. From the exergy and operation point of view, the best scenario was to use a 25% concentration, to prevent destruction losses and operation problems.
Related Concept Videos
Aldehydes and Ketones with Amines: Enamine Formation Mechanism
Preparation of Amines: Alkylation of Ammonia and Amines
Each alkylation step makes the nitrogen center more nucleophilic, which triggers successive alkylations until a quaternary ammonium salt is formed. Considering...
Preparation of Amines: Reductive Amination of Aldehydes and Ketones
Amines to Alkenes: Hofmann Elimination
Under thermal conditions, the hydroxide can abstract a proton from the β carbon; this generates an alkene with the simultaneous...
Aldol Condensation with β-Diesters: Knoevenagel Condensation
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.

