Effect of Compaction Pressure and Moisture Content on Post-Agglomeration Elastic Springback of Pellets

Renewable energy sources (RES) represent an increasing share of global energy production. Biomass has the highest potential of all RES. Biomass is used to produce solid biofuels, liquid biofuels, and gaseous biofuels. One of the main directions of research on solid biofuels is to optimize the agglomeration process. The main factors determining the characteristics of the final product in the production of pellets are process and material parameters. Process parameters include compaction pressure, temperature, and geometry of the matrix channel. The parameters of the material are the type of biomass, moisture content, degree of fragmentation, and method of preparation of the material (e.g., drying). The process of pressure compaction is always associated with the negative phenomenon of elastic springback. The aim of this work was to check the influence of compaction pressure and material moisture content on the springback value. The research was conducted on three materials (giant miscanthus, cup plant and Virginia mallow), using four different pressures (131, 196, 262, and 327 MPa) and three different moisture levels (8, 11, and 14%). For all material springback values, the range was 9-16%. Statistical analysis showed that for all plants tested, the effects of compaction pressure and moisture content significantly affected the elastic springback value. Areas of high value springback in the pattern of process parameters were determined.