Additives and fillers are integral to enhancing the properties of concrete. Pozzolans and blast-furnace slag are additives or admixtures due to their reactions with calcium hydroxide released during cement hydration. Fillers, which are finely ground and similar in fineness to Portland cement, improve concrete attributes such as workability density, and reduce capillary bleeding or cracking. Some fillers possess hydraulic properties or participate in benign reactions within the cement paste.
The...

Depending on the target organ, local anesthetics (LAs) can be administered via various routes. In surface anesthesia, LAs are applied directly to the surface of the skin or mucous membranes. It is widely used for topical skin numbing before venipuncture or minor surgical procedures. Commonly used surface local anesthetics are lidocaine or benzocaine sprays or creams. Surface anesthesia occurs within 5 minutes and lasts for about 60 minutes. One of the main disadvantages of topical anesthesia is...

Local anesthetics (LAs) are commonly used for various applications in medical and dental procedures. Some of the common agents used are cocaine, lidocaine, and bupivacaine.
Cocaine is an ester of benzoic acid and methylecgogine. It is used to anesthetize and vasoconstrict locally. Currently, it is used primarily for topical applications. It is beneficial for surgeries on the upper respiratory tract, providing anesthesia and shrinking the mucosa. Cocaine in the form of cocaine hydrochloride is...

Cavity walls feature a hollow space between the outer and inner wythes, connected only by corrosion-resistant metal ties. When water seeps through the outer wythe, it descends within this cavity, intercepted by flashing and eventually exiting through weep holes. To enhance moisture resistance, the inner wythe's cavity side often receives damp-proofing, doubling as an air barrier. The cavity can also house insulation to mitigate heat transfer.
Maintaining a clean cavity during construction...

Veneer refers to a thin sheet of wood, typically produced to a thickness of about one-eighth of an inch or less. This material is crafted through various methods, the most common being rotary cutting. In this process, a log is mounted into a large lathe and spun against a knife edge, peeling off a continuous strip of wood as the knife penetrates deeper into the rotating log, creating a rotary-cut veneer.
Other veneering techniques include plain-slicing, quarter-slicing, and rift-slicing. These...

Spinal anesthetics are given during lower abdomen and limb surgeries to block sensory and motor neurons. They are administered in the mid to low lumbar regions, primarily acting on the cauda equina's nerve roots. The blockade level depends on the local anesthetic (LA) concentration. Usually, low LA concentrations are sufficient to block sensory fibers, while only high LA concentrations block motor fibers. Other factors like injection volume and speed, the patient's posture, and the drug...