Phosphate removal using thermally regenerated Al adsorbent from drinking water treatment sludge

Alum sludge (AS) is an abundant and ubiquitous residue generated from drinking water treatment plants. AS was thermally treated to use as an adsorbent for phosphate removal from wastewater. Organic matter in the AS was a potential competitor and can deter phosphate adsorption. Pyrolysis and drying of AS were adopted to enhance phosphate removal by eliminating organic matter and enriching Al content. Adsorption kinetics showed that phosphate removal was highest with the AS pyrolyzed at 700 °C followed by 500 °C, air-dried and oven-dried (105 °C). Adsorption kinetic modelling showed that chemisorption is the operative mechanism of phosphate removal in all the AS. Adsorption isotherms also showed that the pyrolyzed AS and air-dried AS had similar adsorption capacity of 30.83-34.53 mg P/g AS. Al dissolution was less than 2 mg/g Al in all the AS samples. COD release was significant in the dried AS, up to 8.0 mg COD/g AS, whereas the pyrolyzed AS released less than 1 mg COD/g AS. FTIR and SEM-EDS analyses of the AS after phosphate adsorption showed the formation of aluminum-phosphate complex. Overall, the pyrolysis of AS at 700 °C was most effective in removing phosphate without leaving secondary pollution.