Related Experiment Video
Updated: Nov 12, 2025

Real-Time Dynamic Navigation System for the Precise Quad-Zygomatic Implant Placement in a Patient with a Severely Atrophic Maxilla
Published on: October 18, 2021
Zygomatic-maxillary cortical bone thickness in hyper, normo and hypodivergent patients
Julyano Vieira da Costa1, Adilson L Ramos1, Liogi Iwaki Filho1
1Universidade Estadual de Maringá, Departamento de Odontologia (Maringá/PR, Brazil).
Objective:
The aim of this study was to evaluate the thickness of the zygomatic-maxillary cortical bone using computed tomography in different skeletal patterns.
Methods:
A total of 54 patients of both sexes, divided into three groups according to the vertical skeletal pattern, were evaluated for cortical bone thickness of the anterior slope of the zygomatic process of the maxilla, using cone beam computed tomography. Measurements were made at 2mm, 4mm, 6mm, 8mm and 10mm above from first molar mesial root apex. Vertical skeletal pattern was determined by Frankfurt mandibular angle (FMA).
Results:
The hyperdivergent pattern had the lowest cortical thickness value, nevertheless, no patient in the hyperdivergent group presented cortical thickness exceeding 2mm, and no patient in the hypodivergent group presented cortical thickness less than 1mm. However, the correlation between cortical thickness and mandibular plane angle was weak and not significant.
Conclusion:
Although higher prevalence of thick cortical was observed in the hypodivergent patients, and thin cortical groups in the hyperdivergent group, the vertical skeletal pattern could not be used as determinant of the zygomatic-maxillary cortical thickness.
Related Concept Videos
Cranial Bones: Superior and Posterior View
The frontal bone is the single bone that forms the forehead. At its anterior midline, between the eyebrows, there is a slight depression called the glabella. The frontal bone also forms the supraorbital margin of the orbit. Near the middle of this margin is the supraorbital foramen, the opening that provides passage for a sensory nerve to the forehead. The frontal bone is thickened just above each supraorbital margin,...
Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...
Compact Bone
Compact bone, also called cortical bone, is the denser, stronger of the two types of bone tissue. It is found under the periosteum and in the diaphyses of long bones, where it provides support and protection. The microscopic structural unit of compact bone is called an osteon, or haversian system. Each osteon is composed of concentric rings of calcified...
Gross Anatomy of Bone
The diaphysis is the tubular shaft that runs between the proximal and distal ends of the bone. The walls of the diaphysis are composed of dense and hard compact bone made of numerous osteons — the functional unit of the compact bone. The hollow region in the diaphysis is called the medullary cavity, which harbors the bone marrow. In infants and children, this marrow cavity is filled with red marrow, whereas in...
Deformations in a Transverse Cross Section
As the material stretches, it expands or contracts in orthogonal directions to the load. This phenomenon varies...

