Related Experiment Video
Updated: Nov 10, 2025

Pore-scale Imaging and Characterization of Hydrocarbon Reservoir Rock Wettability at Subsurface Conditions Using X-ray Microtomography
Published on: October 21, 2018
Impact of water-rock interaction on the pore structures of red-bed soft rock
Meiling Zhou1,2, Jianlin Li1, Zuosen Luo1
1Key Laboratory of Geological Hazards on Three Gorges Reservoir Area of Ministry of Education, China Three Gorges University, Yichang, 443002, Hubei, China.
Abstract:
The physical and mechanical properties of the reservoir bank slope are affected by the water-rock interaction. However, few studies considered the impact of long-term water-rock interaction on the evolution law of mesostructure. Therefore, in this study, the water-rock interaction test was conducted on a slightly weathered red-bed soft rock from the Three Gorges Reservoir area, considering the fluctuation in the reservoir water level. The corresponding pore structure parameters were measured and analyzed based on a scanning electron microscope (SEM) and digital image processing technology. The study showed that: (1) The pore size has been gradually increased, while the number of pores was increased initially and then decreased. Within 12 cycles, the maximum and average pore radius of the rock specimens was increased by 101.02% and 43.32%, respectively, and the porosity has been increased by 26.59%, whereas the number of pores decreased by 22.65%. This indicates the effect of water-rock interaction on the propagation of pores. (2) The pores were changed from oblate to slender by the water-rock interaction. The shape factor was decreased by about 15.79% within 12 cycles. In the meantime, the fractal dimension was increased from 1.20 to 1.28, and more complex structures of pores were observed. (3) The porosity evolution model for the red-bed soft rock was established based on the curve fitting technique. The results can be used as a reference to conceptualize the mesostructure damage of rocks under water-rock interaction.
More Related Videos
Related Concept Videos
Pore Size Distribution
Adequate...
Unsoundness of Aggregate due to Volume Change
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Porosity in Cement Paste
The balance of water to cement in the mix is...
Effect of Sea Water on Concrete
Concrete in areas between tide marks,...
Permeability of Concrete

