Sunlight-induced photocatalytic degradation of various dyes and bacterial inactivation using CuO-MgO-ZnO...

Novel tri-phase CuO-MgO-ZnO nanocomposite was prepared using the co-precipitation technique and investigated its physical properties using characterization techniques including XRD, FTIR, Raman, IV, UV-vis, PL, and SEM. The application of grown CuO-MgO-ZnO nanocomposite for the degradation of various dyes under sunlight and antibacterial activity against different bacteria were studied. The XRD confirmed the existence of diffraction peaks related to CuO (monoclinic), MgO (cubic), and ZnO (hexagonal) with CuO phase 40%, MgO 24%, and ZnO 36%. The optical energy gap of nanocomposite was 2.9 eV, which made it an efficient catalyst under sunlight. Raman and FTIR spectra have further confirmed the formation of the nanocomposite. SEM images revealed agglomerated rod-shaped morphology. EDX results showed the atomic percentage of a constituent element in this order Cu>Zn>Mg. PL results demonstrate the presence of intrinsic defects. The photocatalytic activity against methylene blue (MB), methyl orange (MO), rhodamine-B (RhB), cresol red (CR), and P-nitroaniline (P-Nitro) dyes has shown the excellent degradation efficiencies 88.5%, 93.5%, 75.9%, 98.8%, and 98.6% at 5 ppm dye concentration and 82.6%, 83.6%, 64.3%, 93.1%, and 94.3% at 10 ppm dye concentration in 100 min, respectively, under sunlight illumination. The higher degradation is due to the generation of superoxide and hydroxyl radicals. The recyclability test showed the reusability of catalyst up to the 5th cycle. The antibacterial activity against Escherichia coli, Klebsiella pneumoniae, Proteus Vulgaris, Staphylococcus aureus, and Pseudomonas aeruginosa bacteria with the zone of inhibition 30, 31, 30, 30, and 30 mm, respectively, was achieved.