Related Experiment Video
Updated: Nov 10, 2025
A Personalized 3D-Printed Model for Preoperative Evaluation in Thyroid Surgery
Published on: February 17, 2023
Application of low-dose CT to the creation of 3D-printed kidney and perinephric tissue models for laparoscopic
Guan Li1, Jie Dong2, Zhiqiang Cao3
1Department of Radiology, Jinling Hospital, Medical School of Nanjing University, Nanjing, China.
Purpose:
The aim of this study was to explore the feasibility of 3D printing of kidney and perinephric fat based on low-dose CT technology.
Patients And Methods:
A total of 184 patients with stage T1 complex renal tumors who underwent laparoscopic nephrectomy were prospectively enrolled and divided into three groups: group A (conventional dose kidney and perinephric fat 3D printing group, n = 62), group B (low-dose kidney and perinephric fat 3D printing, n = 64), and group C (conventional dose merely kidney 3D printing group, n = 58). The effective dose (ED), signal-to-noise ratio (SNR), and contrast-to-noise ratio (CNR) were determined. The 3D printing quality was evaluated using a 4-point scale, and interobserver agreement was assessed using the intraclass correlation coefficient (ICC).
Results:
The ED of group B was lower than that of group A, with a decrease of 55.1%. The subjective scores of 3D printing quality in all groups were 3 or 4 points. The interobserver agreement among the three observers in 3D printing quality was good (ICC = 0.84-0.92). The perioperative indexes showed that operation time (OT), warm ischemia time (WIT), estimated blood loss (EBL), and laparoscopic partial nephrectomy (LPN) conversion to laparoscopic radical nephrectomy (LRN) in groups A or B were significantly less than those in group C. LPN was more frequent in group A and group B than in group C (all p < 0.017). There were no significant differences in perioperative indexes between group A and group B (all p > 0.017).
Conclusion:
Low-dose CT technology can be effectively applied to 3D printing of kidney and perinephric fat and reduce the patient's radiation dose without compromising 3D printing quality. 3D printing of kidney and perinephric fat can significantly increase the success rate of LPN and decrease OT, WIT, and EBL.
