Related Experiment Video
Updated: Nov 10, 2025

A Rapid Method for Modeling a Variable Cycle Engine
Published on: August 13, 2019
Tdnn-Based Engine In-Cylinder Pressure Estimation from Shaft Velocity Spectral Representation
Andrés F Valencia-Duque1, David A Cárdenas-Peña1, Andrés M Álvarez-Meza2
1Automatics Research Group, Engineering Faculty, Universidad Tecnológica de Pereira, Pereira PC 660001, Colombia.
Abstract:
Pressure is one of the essential variables to give information about engine condition and monitoring. Direct recording of this signal is complex and invasive, while angular velocity can be measured. Nonetheless, the challenge is to predict the cylinder pressure using the shaft kinematics accurately. In this paper, a time-delay neural network (TDNN), interpreted as a finite pulse response (FIR) filter, is proposed to estimate the in-cylinder pressure of a single-cylinder internal combustion engine (ICE) from fluctuations in shaft angular velocity. The experiments are conducted over data obtained from an ICE operating in 12 different states by changing the angular velocity and load. The TDNN's delay is adjusted to get the highest possible correlation-based score. Our methodology can predict pressure with an R2 >0.9, avoiding complicated pre-processing steps.
More Related Videos
06:45Design and Application of a Fault Detection Method Based on Adaptive Filters and Rotational Speed Estimation for an Electro-Hydrostatic Actuator
Published on: October 28, 2022
09:04A Modeling and Simulation Method for Preliminary Design of an Electro-Variable Displacement Pump
Published on: June 1, 2022
Related Concept Videos
Thin-Walled Hollow Shafts
Pressure Variation in a Fluid at Rest
When measuring pressure at two different levels within the fluid, the difference in...
Measurement of Fluid Pressure
A basic form of manometer is the piezometer, a vertical tube open at the top and filled with the same...
Net Torque Calculations
Conservation of Energy in Control Volume
For steady flow systems, the time derivative of the stored energy becomes zero since there is no energy accumulation within the control volume. This simplifies the energy equation to:
Static, Stagnation, Dynamic and Total Pressure