Related Experiment Video
Updated: Aug 5, 2026

The Use of Drip Flow and Rotating Disk Reactors for Staphylococcus aureus Biofilm Analysis
Published on: December 27, 2010
Comparisons of nitrite accumulation, microbial behavior and nitrification kinetic in continuous stirred tank (ST) and
Miao Zhang1, Jing Gao1, Yajun Fan1
1College of Environmental Science and Engineering, Yangzhou University, Yangzhou, 225127, PR China.
Abstract:
Two types of continuous stirred tank moving bed biofilm reactors (ST-MBBR) and plug flow MBBR (PF-MBBR) were compared for nitrification. PF-MBBR showed strong shock resistance to temperature, and ammonium oxidation ratio (AOR) was 9.63% higher than that in the ST-MBBR, although the average biomass and biofilm thickness of ST-MBBR were 7.32-18.59%, 9.44-14.06% higher than those in the PF-MBBR. Meanwhile, a lower nitrite accumulation ratio (NAR) was observed (54.88%) in the PF-MBBR than the ST-MBBR (78.92%) due to different operation modes, and the divergence was demonstrated by the microbial quantitative analysis. Nitrification kinetics revealed that the temperature coefficient (θ) in the ST-MBBR (1.068) was much higher than that in the PF-MBBR (1.006-1.015), proving the contrasting nitrification performances caused by temperature shock. According to the Monod equation, the half-saturation coefficient (KN) in the ST-MBBR was 0.19 mg/L while it varied around 0.12-0.24 mg/L in the PF-MBBR, revealing various NH4+ affinity owing to different biofilm thickness and microbial composition. Finally, MBBR optimization related to operation mode, temperature, and free ammonium (FA) inhibition for nitrite accumulation was discussed.
More Related Videos
08:13A Novel Bioreactor for High Density Cultivation of Diverse Microbial Communities
Published on: December 25, 2015
08:05Measurement of the Potential Rates of Dissimilatory Nitrate Reduction to Ammonium Based on 14NH4+/15NH4+ Analyses via Sequential Conversion to N2O
Published on: October 7, 2020
Related Concept Videos
Bioreactor Design and Operational System
Bioreactor Controls-II
Batch vs Continuous Culture