Related Experiment Video
Updated: Nov 9, 2025
An Inertial Measurement Unit Based Method to Estimate Hip and Knee Joint Kinematics in Team Sport Athletes on the Field
Published on: May 26, 2020
A data process of human knee joint kinematics obtained by motion-capture measurement
Jian-Ping Wang1, Shi-Hua Wang1, Yan-Qing Wang2
1School of Mechanical and Power Engineering, Henan Polytechnic University, Jiaozuo, 454000, China.
Background:
The motion capture has been used as the usual method for measuring movement parameters of human, and most of the measuring data are obtained by partial manual process based on commercial software. An automatic kinematics data process was developed by programming on MATLAB software in this paper.
Methods:
The motion capture measurement of healthy volunteers was carried out and the MATLAB program was used for data process. Firstly, the coordinate data of markers and anatomical points on human lower limb measured by motion capture system were read and repaired through the usual and the patch program. Meantime, the local coordinate systems of human femur and tibia were established with anatomical points. Then flexion/extension, abduction/adduction and internal/external rotation of human knee tibiofemoral joint were obtained by special coordinate transformation program.
Results:
Using the above methods, motion capture measurements and batch data processing were carried out on squatting and climbing stairs of 29 healthy volunteers. And the motion characteristics (flexion/extension, internal/external rotation and adduction/abduction) of the knee joint were obtained. For example, the maximum internal/external rotation in squatting and climbing stairs were respectively was 30.5 degrees and 14 degrees, etc. Meantime, the results of this paper also were respectively compared with the results processed by other research methods, and the results were basically consistent, thus the reliability of our research method was verified. After calibration processing, the compiled MATLAB program of this paper can directly be used for efficient batch processing and avoiding manual modeling one by one.
Conclusion:
A novel Patch Program of this paper has been developed, which can make reasonable compensation for missing and noise signals to obtain more complete motion data. At the same time, a universal data processing program has also been developed for obtaining the relative movement of various components of the human body, and the program can be modified for detail special analysis. These motion capture technologies can be used to judge whether the human body functions are abnormal, provide a reference for rehabilitation treatment and design of rehabilitation equipment, and evaluate the effectiveness before and after surgery.
