Synergistic Effect of Binary Surfactant Mixtures in Two-Phase and Three-Phase Systems

Cationic alkyltrimethylammonium bromides (CTAB, with n = 8, 12, 16, 18) and their mixtures with n-octanol as a nonionic surfactant were chosen as a model system to study the synergistic effect on foamability (two-phase system) and floatability (three-phase system) of quartz in the presence of binary mixtures of ionic/nonionic surfactants. The foam height of one-component solutions and binary mixtures and floatability of quartz particles were characterized as a function of the surfactant concentration and the number of carbons (n) in the alkyl chain of CTAB. The experimental results of foamability and floatability measurements in one-component and mixed solutions revealed the synergistic effect, causing a significant enhancement in the foam height and recovery of quartz. In the presence of n-octanol, the height of foam increased remarkably for all CTAB solutions studied, and this effect, whose magnitude depended on the CTAB hydrophobic tail length, could not be justified by a simple increase in total surfactant concentration. A similar picture was obtained in the case of flotation response. The mechanism of synergistic effect observed in mixed CTAB/n-octanol solutions was proposed. The discussion was supported by molecular dynamics simulations, and the probable mechanism responsible for synergism was discussed. In addition, an analysis allowing accurate determination of the concentration regimes, where the synergistic effect can be expected, was given. It was shown that for the two-phase system, the n-octanol molecule preadsorption at the liquid/gas interface causes an increase in CTAB adsorption coverage over the level expected from its equilibrium value in the one-component solution. In the case of the three-phase system, the synergistic effect was related to the ionic surfactants serving as an anchor layer for n-octanol, which, in water/n-octanol solution (one-component system), do not adsorb on the surface of quartz.