Use of Three-dimensional Titanium Trusses for Arthrodesis Procedures in Foot and Ankle Surgery: A Retrospective Case Series

Periarticular osseous defects pose a challenge when considering arthrodesis. Failure to restore the cubic content of bone can result in shortening and malalignment, as well as subsequent biomechanical issues. This study reports on 12 patients treated with patient-specific 3-D printed (7) and prefabricated titanium trusses (5). Twelve consecutive patients were treated for osseous defects of the forefoot, hindfoot, and ankle with patient-specific, 3D printed or prefabricated manufacturer titanium trusses. Seven were customized, patient-specific 3D printed trusses (4WEB, Frisco, Texas) and 5 were prefabricated manufacturer titanium trusses. All patients had a minimum of 6 months of clinical and radiographic follow-up. and no patients were lost to follow-up. Seven of the 12 patients had a computed tomography (CT) scan performed following surgery. Successful limb or ray salvage was achieved in 11 of 12 patients (91.7%). Six of 7 patients (85.7%) with a postoperative CT scan, went on to complete radiographic consolidation across all arthrodesis sites. The remaining 5 patients showed complete consolidation across the arthrodesis sites on plain film radiographs. Complications included one patient with a residual midfoot deformity that required a subsequent midfoot osteotomy in order to obtain a plantigrade foot following successful tibiotalocalcaneal (TTC) arthrodesis, and a below knee amputation in one patient who underwent revision TTC arthrodesis to salvage avascular necrosis of the talus that developed following the index procedure. Eleven of 12 patients undergoing arthrodesis demonstrated successful union with both customized, patient-specific 3D printed and prefabricated manufacturer titanium trusses on CT scans or radiographs. The average follow-up was 14 months. Reports on traditional methods of addressing periarticular defects in patients requiring arthrodesis show mixed results and relatively high complication rates. Custom, 3D printed and prefabricated titanium truss technology offers an alternative to traditional methods for large, periarticular osseous defects.