Related Experiment Video
Updated: Nov 8, 2025

Testing Tactile Masking between the Forearms
Published on: February 10, 2016
Frequency selectivity in the modulation domain estimated using forward masking: Effects of masker modulation depth
Christian Füllgrabe1, Aleksander Sęk2, Brian C J Moore3
1School of Sport, Exercise and Health Sciences, Loughborough University, Ashby Road, Loughborough LE11 3TU, United Kingdom.
Abstract:
The threshold for detecting amplitude modulation (AM) of a sinusoidal or noise carrier is elevated when the signal AM is preceded by masker AM applied to the same carrier. This effect, called AM forward masking, shows selectivity in the AM domain, consistent with the existence of a modulation filter bank (MFB). In this paper we explore the effect of two factors that can influence AM forward masking, using an 8-kHz sinusoidal carrier and a range of masker AM frequencies, fm, both below and above the signal AM frequency, fs, of 40 Hz. The first factor was the time delay, td, between the end of the masker AM and the start of the signal AM. The second was the AM depth, m, of the masker, which was either 1 or 0.25. The AM forward masking patterns in all conditions showed tuning in the AM domain; signal thresholds were highest when fm was close to fs. The amount of AM forward masking decreased with increasing td in a similar way for all fm, so the shapes of the masking patterns did not change markedly with td. Remarkably, the amount of AM forward masking decreased by only about 3 dB (a non-significant effect) when the masker m was decreased from 1 to 0.25. This result appears to be inconsistent with an explanation of AM forward masking in terms of adaptation in a MFB or in terms of a sliding temporal integrator.
More Related Videos
13:00Measuring Attention and Visual Processing Speed by Model-based Analysis of Temporal-order Judgments
Published on: January 23, 2017
06:46Investigating the Deployment of Visual Attention Before Accurate and Averaging Saccades via Eye Tracking and Assessment of Visual Sensitivity
Published on: March 18, 2019
Related Concept Videos
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original...
Time and frequency -Domain Interpretation of Phase-lead Control
The design of phase-lead control involves the strategic placement of poles and zeros to balance steady-state error and system...
Masking and Demasking Agents
There are many masking agents, such as cyanide, fluoride, triethanolamine, thiourea, and 2,3-bis(sulfanyl)propan-1-ol (formerly 2,3-dimercapto-1-propanol), with the masking agent chosen based on...
Bandpass Sampling
A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2....
Frequency-dependent Selection
Design Example