Related Experiment Video
Updated: Nov 8, 2025

Achieving Moderate Pressures in Sealed Vessels Using Dry Ice As a Solid CO2 Source
Published on: August 17, 2018
Homogeneous water nucleation in carbon dioxide-nitrogen mixtures: Experimental study on pressure and carrier gas
M M Campagna1, J Hrubý2, M E H van Dongen3
1Department of Mechanical Engineering, Eindhoven University of Technology, P.O. Box 513, 5600 MB Eindhoven, The Netherlands.
Abstract:
New homogeneous nucleation experiments are presented at 240 K for water in carrier gas mixtures of nitrogen with carbon dioxide molar fractions of 5%, 15%, and 25%. The pulse expansion wave tube is used to test three different pressure conditions, namely, 0.1, 1, and 2 MPa. In addition, a restricted series of nucleation experiments is presented for 25% carbon dioxide mixtures at temperatures of 234 and 236 K at 0.1 MPa. As pressure and carbon dioxide content are increased, the nucleation rate increases accordingly. This behavior is attributed to the reduction in the water surface tension by the adsorption of carrier gas molecules. The new data are compared with theoretical predictions based on the classical nucleation theory and on extrapolations of empirical surface tension data to the supercooled conditions at 240 K. The extrapolation is carried out on the basis of a theoretical adsorption/surface tension model, extended to multi-component mixtures. The theoretical model appears to strongly overestimate the pressure and composition dependence. At relatively low pressures of 0.1 MPa, a reduction in the nucleation rates is found due to an incomplete thermalization of colliding clusters and carrier gas molecules. The observed decrease in the nucleation rate is supported by the theoretical model of Barrett, generalized here for water in multi-component carrier gas mixtures. The temperature dependence of the nucleation rate at 0.1 MPa follows the scaling model proposed by Hale [J. Chem. Phys. 122, 204509 (2005)].
Related Concept Videos
The Equilibrium Constant
Turbulent Flow: Problem Solving
Temperature is a key factor in CO2 solubility. In this case, the CO2 gas and the liquid are cooled to 20°C. Lower temperatures enhance...
Phase Diagrams
Physical Properties Affecting Solubility
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
Chemical Stoichiometry and Gases: Using Ideal Gas Law to Determine Moles
Van der Waals Equation
First, the attractive forces between molecules, which are stronger at higher densities and reduce the pressure, are considered by adding to the pressure a term equal to the square of the molar density multiplied by a positive coefficient a. Second, the volume...

