Tensile mechanical analysis of anisotropy and velocity dependence of the spinal cord white matter: a biomechanical...

In spinal cord injuries, external forces from various directions occur at various velocities. Therefore, it is important to physically evaluate whether the spinal cord is susceptible to damage and an increase in internal stress for external forces. We hypothesized that the spinal cord has mechanical features that vary under stress depending on the direction and velocity of injury. However, it is difficult to perform experiment because the spinal cord is very soft. There are no reports on the effects of multiple external forces. In this study, we used bovine spinal cord white matter to test and analyze the anisotropy and velocity dependence of the spinal cord. Tensile-vertical, tensile-parallel, shear-vertical, and shear-parallel tests were performed on the white matter in the fibrous direction (cranial to caudal). Strain rate in the experiment was 0.1, 1, 10, and 100/s. We calculated the Young's modulus of the spinal cord. Results of the tensile and shear tests revealed that stress tended to increase when external forces were applied parallel to the direction of axon fibers, such as in tensile-vertical and shear-vertical tests. However, external forces those tear against the fibrous direction and vertically, such as in tensile-parallel and shear-parallel tests, were less likely to increase stress even with increased velocity. We found that the spinal cord was prone to external forces, especially in the direction of the fibers, and to be under increased stress levels when the velocity of external forces increased. From these results, we confirmed that the spinal cord has velocity dependence and anisotropy. The Institutional Animal Care and Use Committee of Yamaguchi University waived the requirement for ethical approval.