Related Experiment Video
Updated: Nov 7, 2025

Experimental Protocol to Determine the Chloride Threshold Value for Corrosion in Samples Taken from Reinforced Concrete Structures
Published on: August 31, 2017
A Research on Durability Degradation of Mineral Admixture Concrete
Xupeng Chen1, Zhuowen Sun2, Jianyong Pang1
1School of Civil Engineering and Architecture, Anhui University of Science and Engineering, Huainan 232001, China.
Abstract:
In order to study the degradation laws and mechanisms of admixture concretes with single-added SO42- and composite of Mg2+ and SO42-, respectively, the durability tests were conducted on three types of mineral admixture concretes (concretes with single-added metakaolin (MK), single-added ultra-fine fly ash (UFA), and composite of metakaolin and ultra-fine fly ash (MF), and one reference concrete. In these tests, the 10% Na2SO4 solution and the 10% MgSO4 solution were used as the erosion medium, and the drying-wetting circle method was applied. It can be seen from the compressive tests and grey relational analysis that the MK admixture can improve the anti-Na2SO4-erosion capability of the concrete significantly, but weaken its anti-MgSO4-erosion capability; the UFA admixture can improve both the anti-Na2SO4-erosion and the anti-MgSO4-erosion capability of the concrete; and the composite admixture has superimposed effects and can enhance erosion resistance against these two erosion mediums. The phase composition and the changes of the macro morphology and the micro structure during the erosion process caused by mono sulfate ions and complex ions has been observed through X-ray diffraction (XRD), FTIR spectrum (FTIR), and scanning electron microscope (SEM), based on which it was determined that the erosion of single-added SO42- ions can produce erosive outputs of ettringite, gypsum, and mirabilite in the concrete, and cause corner scaling or deformation. Mg2+ and SO42- reacted in the concrete and produced brucite, M-S-H, ettringite, and gypsum, etc. The erosion of complex ions can cause scaling of the cement mortar and aggregate from the surface or the desquamation of corners.
More Related Videos
06:27Expression of Cementitious Pore Solution and the Analysis of Its Chemical Composition and Resistivity Using X-ray Fluorescence
Published on: September 23, 2018
05:38Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
Related Concept Videos
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...
Effect of Sea Water on Concrete
Concrete in areas between tide marks,...
Effects of Air-entrainment in Concrete
Microcracking in Concrete
Frost Resistant Concrete
Introducing microscopic air bubbles into the concrete mix through air entrainment creates small voids that accommodate ice expansion, thereby reducing internal pressures and preventing cracking. The optimal amount of...