Evaluation of Bonding Gap Control Methods for an Epoxy Adhesive Joint of Carbon Fiber Tubes and Aluminum Alloy...

The aim of this paper is to compare two methods of epoxy adhesive bond gap control: one with a geometrical (mechanical) solution and the other with glass beads, which have the diameter of the desired bond gap and are mixed with an epoxy adhesive. The adhered materials were carbon fiber composite tubes and aluminum alloy inserts, which were used as wishbones in a suspension system of a motorsport vehicle. It was assumed that the gap thickness would be equal to 0.2 mm and the length of a bond would be 30 mm. The internal diameter of the tubes was 14 mm and 18 mm, whereas the inserts' external diameter was 13.6 mm and 17.6 mm. Their surface has been subjected to mechanical treatment with sand paper starting from 240 grit up to 400. The adhesives used were EA 3425 and EA 9466 cured at 80 °C for 2 h. The results showed that the glass beads method provides more consistent and better results as compared to the geometrical (mechanical) method. Further study in the area of fatigue and interfacial failure modes could be useful.