Comparison of Starts and Turns between Individual and Relay Swimming Races

Xiao Qiu1, Blanca De la Fuente2, Alberto Lorenzo3

  • 1Health and Human Performance Department, Universidad Politécnica de Madrid, 28040 Madrid, Spain.

Related Concept Videos

Transformers with Off-Nominal Turns Ratios01:25

Transformers with Off-Nominal Turns Ratios

In scenarios involving parallel transformers with disparate ratings, developing per-unit models requires accommodating off-nominal turns ratios. This situation arises when the selected base voltages are not proportional to the transformer’s voltage ratings. Consider a transformer where the rated voltages are related by the term a. If the chosen voltage bases satisfy a relationship involving term b, term c is defined as the ratio of these bases. This ratio is then substituted into the...
261
Directional Relays01:25

Directional Relays

Directional relays, essential for managing unidirectional fault currents, enhance the safety and efficiency of power systems. On power lines equipped with directional relays, faults downstream (to the right) of the current transformer typically cause the fault current to lag the bus voltage by approximately 90 degrees, known as the forward direction. In contrast, upstream (left-side) faults may result in the fault current leading the bus voltage by nearly 90 degrees, termed the reverse...
296
Current Dividers01:10

Current Dividers

In parallel electrical connections, resistors are linked between the same pair of nodes, creating an equal voltage across each resistor. Kirchhoff's current law is applied to these connections, establishing that the sum of currents through these resistors equals the source current. Utilizing Ohm's law, the source current is determined as the product of the source voltage and the sum of the reciprocals of individual resistances. This relationship simplifies the process of finding the current...
753
Comparison between RL and RC circuits01:24

Comparison between RL and RC circuits

An RC circuit consists of resistance and capacitance, while in an RL circuit, capacitance is replaced by an inductor. RL and RC circuits are first-order differential circuits that store energy. An RC circuit stores energy in the electric field, while an RL circuit stores energy in the magnetic field. When connected to a battery, an RC circuit charges the capacitor, causing the current to decrease from maximum to zero upon being fully charged. This increases the voltage across the capacitor from...
5.2K
Wald-Wolfowitz Runs Test I01:17

Wald-Wolfowitz Runs Test I

The Wald-Wolfowitz test, also known as the runs test, is a nonparametric statistical test used to assess the randomness of a sequence of two different types of elements (e.g., positive/negative values, successes/failures). It examines whether the order of the elements in a sequence is random or if there is a pattern or trend present. This nonparametric test applies to any ordered data despite the population and sample data distribution, even if a higher sample size is available.
The test works...
786
Multiple Comparison Tests01:13

Multiple Comparison Tests

Multiple comparison test, abbreviated as MCT, is a post hoc analysis generally performed after comparing multiple samples with one or more tests. An MCT will help identify a significantly different sample among multiple samples or a factor among multiple factors.
It would be easy to compare two samples using a significance alpha level of 0.05. In other words, there is only one sample pair to be compared. However, it would be difficult to identify a significantly different sample if the number...
4.1K