Power Spectrum Features of Acupoint Bioelectricity Signal

Since the 1950s, many studies have been conducted on the electrical properties of acupuncture points (acupoints), especially their bio-resistance characteristics. Results of such studies have been inconclusive due to factors such as sweat gland density and compounding factors of applying electrical stimulation. In this study, a power spectrum instrument was used to assess the power spectrum and power of acupoints and nonacupoints without electrical stimulation. Using such instrumentation, specificity of electrical signals of acupoints was also explored.

Thirty-six subjects (29 females, 7 males) participated in the study. Stainless steel acupuncture needles (diameter 0.35 mm; length 50 mm) were used. Five acupoints were tested: ST 36, SP 6, GB 39, GB 37, and K I9. Four control sites 0.5-1.0 cm adjacent to each acupoint were chosen. After needle insertion into the acupoint and control sites, the needles were attached to the power spectrum instrument to acquire any electrical signals. Acquire signals were analyzed using self-written software.

Power spectrum difference between acupoint and nonacupoint signals was 0-2 Hz. Results of t-test or signed rank sum test (α = 0.05) found that electrical signals between acupoints and nonacupoints were markedly different (P < 0.05).

Acupoint bioelectricity signals are higher than adjacent nonacupoints. The most significant difference is distributed between 0 Hz and 2 Hz.