Three-dimensional printing of gastro-floating tablets using polyethylene glycol diacrylate-based photocurable...

Extruded three-dimensional (3D) printing based on photocurable materials has shown good application prospects in the medical field. This has been attributed to the operational aspect that can be performed at room temperature and the high mechanical strength of the extrudate and final product. However, the commonly used photocurable polymer, polyethylene glycol diacrylate (PEGDA), has a low viscosity and exhibits a long crosslinking time. Therefore, additives are added to improve the printability of the extrudate. In this study, various hydrogels were used to improve the mixing uniformity and rheological behavior of PEGDA-based printing materials. Printing accuracy and mechanical strength were evaluated to optimize print material composition and process parameters. Hydroxypropyl methylcellulose K100M was found to improve the shear thinning and self-supporting properties of printing materials, which were essential for printability. Although the storage modulus of the photocured material proportionally increased with curing time in the range of 20-80 s, the minimal layer time of the 3D samples remained at 65 s, ensuring interlayer adhesion. Gastro-floating tablets with different infill densities were printed to illustrate the application of 3D extrusion printing in personalized medicine. The weight, crushing strength, and floating time were regulated by the infill density of the models. Overall, this study demonstrates that extrusion printing with a photocurable material is an easy way to prepare customized oral preparations with complex internal structures and tunable properties.