Related Experiment Video
Updated: Nov 6, 2025

Electrochemically and Bioelectrochemically Induced Ammonium Recovery
Published on: January 22, 2015
Electrochemical Ammonia Recovery from Anaerobic Centrate Using a Nickel-Functionalized Activated Carbon Membrane
Kyoung-Yeol Kim1, Daniel A Moreno-Jimenez1, Harry Efstathiadis2
1Department of Environmental and Sustainable Engineering, University at Albany, State University of New York, 1400 Washington Avenue, Albany, New York 12222, United States.
Abstract:
Ammonia (NH3) recovery from used water (previously wastewater) is highly desirable to depart from fossil fuel-dependent NH3 production and curb nitrogen emission to the environment. Electrochemical NH3 recovery is promising since it can simply convert aqueous NH4+ to gaseous NH3 using cathodic reactions (OH- generation). However, the use of a separated electrode and membrane imposes high resistances to the cathodic reaction and NH3 transfer. This study examined an activated carbon (AC)-based membrane electrode functionalized with nickel to electrochemically recover NH3 from synthetic anaerobic centrate. The membrane electrode was fabricated using nickel-adsorbed AC powder and a polyvinylidene fluoride (PVDF) binder, and the PVDF membrane layer was formed at the electrode surface by phase inversion. The NH3-N recovery flux of 50.3 ± 0.4 gNH3-N/m2/d was produced at 17.1 A/m2 with a recovery solution at pH 7, and NH3-N fluxes and energy consumptions were improved as the recovery solution became acidic (62.2 ± 2.1 gNH3-N/m2/d with 16.0 ± 1.6 kWh/kgNH3-N at pH 2). Increasing PVDF loadings did not impact the electrochemical performances of the Ni/AC-PVDF electrode, but slightly lower (7%) NH3-N fluxes were obtained with higher PVDF loadings. Ni dissolution (3.7-6.0% loss) was affected by the recovery solution pH, but it did not impact the performances over the cycles.
More Related Videos
10:57Synthesis and Performance Characterizations of Transition Metal Single Atom Catalyst for Electrochemical CO2 Reduction
Published on: April 10, 2018
08:40Synthesis of Metal Nanoparticles Supported on Carbon Nanotube with Doped Co and N Atoms and its Catalytic Applications in Hydrogen Production
Published on: December 6, 2021
Related Concept Videos
Catalysis
Potentiometry: Membrane Electrodes
Metabolism of Chemolithotrophs
Electrodeposition
Electrodeposition can...
Precipitation Gravimetry
In determining nickel by gravimetric analysis, a precipitant of ethanolic dimethylglyoxime is added to a hot nickel salt solution. This is quickly followed by the dropwise addition of dilute ammonia solution until precipitation occurs. A...