Related Experiment Video
Updated: Nov 6, 2025
Minimally Invasive Treatment for Thoracolumbar Burst Fracture Using Sagittal Alignment Screws and A Trauma Reduction Device
Published on: November 8, 2024
Odontoid Fracture as Proximal Junctional Failure in Patients With Multilevel Spine Fusions
Bryan M Ladd1, Christopher T Martin2, Jonathan N Sembrano2
1Department of Neurosurgery, University of Minnesota, Minneapolis, MN, USA.
Study Design:
Retrospective study.
Objective:
Proximal junctional failure (PJF) commonly occurs as a recognized potential outcome of fusion surgery. Here we describe a unique series of patients with multilevel spine fusion including the cervical spine, who developed PJF as an odontoid fracture.
Methods:
We performed a single site retrospective review of patients with prior fusion that included a cervical component, who presented with an odontoid fracture between 2012 and 2019. Radiographic measurements included C2-C7 SVA, C2-C7 lordosis, T1 slope, Occiput-C2 angle, proximal junctional kyphosis, and cervical mismatch. Associated fractures, medical comorbidities, and treatments were determined via chart review after IRB approval.
Results:
Nine patients met inclusion criteria. 5 reported trauma with subsequent onset of pain. All patients sustained a Type II odontoid fracture. 5 with associated C1/Jefferson fractures. In all patients, pre-injury Occiput-C2 angle was outside normative range; C2-C7 SVA was greater than 4 cm in 6 patients; T1-slope minus cervical lordosis was greater than 18.5 degrees in 6 patients. 7 patients were treated operatively with extension of fusion to C1 and 2 patients declined operative treatment.
Conclusion:
In this series of 9 patients with multilevel fusion with type II odontoid fractures, all patients demonstrated abnormal pre-fracture sagittal alignment parameters and a greater than normal association of C1 fractures was noted. Further study is needed to establish the role of poor sagittal alignment with compensatory occiput-C2 angulation as a predisposing factor for odontoid fracture as a proximal junctional failure mechanism.
Related Concept Videos
01:27Fractures: Bone Repair
Minor fractures with no bone displacement are treated by immobilizing the fractured bone using a cast or splint. However, in the case of fractures with displaced bones, the broken bones are repositioned before immobilization to ensure successful healing without deformation and loss of function. The realignment of fractured bone ends is performed through a process called reduction. If the...
01:22Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...
01:28Articulations of the Vertebral Column
01:17Structural Joints: Cartilaginous Joints
There are two types of cartilaginous joints:
Synchondrosis
A synchondrosis ("joined by cartilage") is a cartilaginous joint where bones are connected by hyaline cartilage. Synchondrosis may be temporary...
01:03Structural Joints: Fibrous Joints
Suture
All the bones of the skull, except for the mandible, are joined to each other by a fibrous joint called a suture. The fibrous connective tissue found at a suture strongly unites the adjacent skull bones and thus helps to protect the brain and form the face. In...
01:09Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An...