Estimation and assessment of sagittal spinal curvature and thoracic muscle morphometry in different postures

Spine models are typically developed from supine clinical imaging data, and hence clearly do not fully reflect postures that replicate subjects' clinical symptoms. Our objectives were to develop a method to: (i) estimate the subject-specific sagittal curvature of the whole spine in different postures from limited imaging data, (ii) obtain muscle lines-of-action in different postures and analyze the effect of posture on muscle fascicle length, and (iii) correct for cosine between the magnetic resonance imaging (MRI) scan plane and dominant fiber line-of-action for muscle parameters (cross-sectional area (CSA) and position). The thoracic spines of six healthy volunteers were scanned in four postures (supine, standing, flexion, and sitting) in an upright MRI. Geometry of the sagittal spine was approximated with a circular spline. A pipeline was developed to estimate spine geometry in different postures and was validated. The lines-of-action for two muscles, erector spinae (ES) and transversospinalis (TS) were obtained for every posture and hence muscle fascicle lengths were computed. A correction factor based on published literature was then computed and applied to the muscle parameters. The maximum registration error between the estimated spine geometry and MRI data was small (average RMSE∼1.2%). The muscle fascicle length increased (up to 20%) in flexion when compared to erect postures. The correction factor reduced muscle parameters (∼5% for ES and ∼25% for TS) when compared to raw MRI data. The proposed pipeline is a preliminary step in subject-specific modeling. Direction cosines of muscles could be used while improving the inputs of spine models.