Related Experiment Video
Updated: Nov 5, 2025
Polytetrafluoroethylene PTFE as a Suture Material in Tendon Surgery
Published on: October 6, 2022
An ex vivo biomechanical comparison of two suture materials and two pattern combinations for equine superficial
Andrea Giacchi1, Mattie A McMaster1
1Weipers Centre Equine Hospital, School of Veterinary Medicine, University of Glasgow, Glasgow, UK.
Objective:
To compare biomechanical characteristics of three-loop pulley (3LP) pattern versus Bunnell technique (BT) using polydioxanone (PDS) suture; to determine the influence of polyester tape (PT) versus PDS on the BT for equine superficial digital flexor tendon (SDFT) tenorrhaphy; to compare BT with PT versus 3LP with PDS.
Study Design:
Ex vivo biomechanical study.
Sample Population:
Forty equine forelimb SDFT.
Methods:
Two experiments were performed: (1) 10 SDFT pairs were repaired with 3LP or BT using PDS; (2) 10 SDFT pairs were repaired with PDS or PT using BT. Load at failure, mode of failure, load at 2 mm gap, and gap at failure were obtained using a material testing machine.
Results:
In experiment 1, 3LP + PDS1 had higher loads at failure (p < .001) and at 2 mm gap (p < .001), and smaller gap at failure than BT + PDS1 (p = .024). In experiment 2, BT + PT2 had higher loads at failure (p < .001) and at 2 mm gap (p = .001), and larger gap at failure (p = .004) than the BT + PDS2 . 3LP + PDS1 and BT + PT2 mostly failed by suture/implant pull-through while BT + PDS failed by suture breakage. BT + PT2 had greater load (p = .035) and gap at failure (p < .001) than 3LP + PDS1, with no difference in load at 2 mm gap (p = .14).
Conclusion:
The use of BT may be justified over 3LP if combined with PT. However, the larger size of the PT required stab incisions in the tendon for placement and was subjectively more difficult to place than PDS.
Clinical Significance:
The BT + PT, although the strongest among the tested repairs, would only be able to withstand 12%-24% of the load encountered by the SDFT at walk.
