3D printed furosemide and sildenafil tablets: Innovative production and quality control

Three-dimensional (3D) printing of pharmaceuticals has the potential to revolutionise personalised medicine but is as yet largely unexplored. A proof-of-concept study of a novel heated, piston-driven semi-solid extrusion 3D printer was performed by producing furosemide and sildenafil tablets for paediatric patients. The average weight of the tablets was 141.1 mg (RSD 1.26%). The acceptance values of the content uniformity were 4.2-10.6 (concentration RSD 0.41-0.63%), 4.8-8.9 (concentration RSD 0.76-0.97%) and 6.6-9.2 (concentration RSD 0.94-1.44%) for furosemide 2 mg, 10 mg and sildenafil 4 mg, respectively. The dissolution rate limiting step was the dissolving and eroding of the tablet matrix and showed an immediate release. The tablets complied to the requirements of the European Pharmacopoeia (EP) for uniformity of mass (EP 2.9.5), content uniformity (EP 2.9.40) and conventional release (EP 2.9.3). While they complied, not all of these quality tests for tablets might be suitable for 3D printed tablets due to the layering of the tablets and the small batch production. To assess adequate layer adhesion adjusted friability (EP 2.9.7) and resistance to crushing (EP 2.9.8) tests are proposed.