Asbestos-contaminated drinking water: its impact on household air

Asbestos contamination in excess of 10 billion fibers per liter was detected in a community's drinking water. To assess the possibility of waterborne asbestos becoming airborne, air samples were collected from impacted houses receiving contaminated water from three control houses. Collected within each house were three samples on 0.6-micrometer-pore Nuclepore filters and three samples on 0.8-micrometer-pore Millipore filters. In addition, bulk samples of suspect material and water samples were collected. Mean waterborne asbestos concentrations were 24 million fibers per liter (MFL) in the impacted houses versus only 1.1 MFL in the control houses. Transmission electron microscopy revealed that airborne asbestos concentrations were highest in impacted houses, with airborne asbestos concentrations positively correlated with waterborne concentrations. For fiber and mass measurements on both filter types, airborne asbestos concentrations were significantly higher in the impacted houses: mean concentrations in impacted houses were 0.12 fibers/cm3 and 1.7 ng/m3 on Nuclepore filters and 0.053 fibers/cm3 and 2.3 ng/m3 on Millipore filters versus only 0.037 fibers/cm3 and 0.31 ng/m3 on Nuclepore filters and 0.0077 fibers/cm3 and 0.14 ng/m3 on Millipore filters from control houses. Also detected in the air samples from impacted houses were clusters of chrysotile, often with several hundreds of fibers. When estimates of these individual fibers were added to the total fiber count, the difference between the impacted and control houses became even greater. The increased concentrations in impacted houses were due primarily to short (less than 1 micrometer) fibers. Bulk samples did not reveal likely materials within the impacted houses to account for these differences. Thus high levels of waterborne asbestos were apparently the source of increased concentrations of airborne asbestos within these houses.