Fault Identification for a Class of Nonlinear Systems of Canonical Form via Deterministic Learning
Abstract:
In this article, through a combination of the deterministic learning (DL) method and the adaptive high gain observer (AHGO) technology, a fault identification approach for a class of nonlinear systems in canonical form is proposed. By using the DL method, the partial persistent excitation condition of the identification system is satisfied, and then, the AHGO technology is exploited to estimate the states and the neural network weights simultaneously. To analyze the convergence of the proposed method, we first analyze the uniformed completely observability (UCO) property of the linear part of the nonlinear identification system. Then, by using the Lipschitz property of the nonlinear item and the Bellman-Gronwall lemma, we show that the UCO property of the nonlinear identification system is depended on the UCO property of the linear part when the observer gain is chosen large. Therefore, by using the UCO property of the nonlinear identification system and the Lyapunov stability theorem, the convergence of the proposed learning observer is proven. The attraction of this article is based on the analysis of the UCO property of the identification system, and the convergence of the proposed learning observer can be directly proven. The simulation example is given to demonstrate the effectiveness of the proposed method.
Related Concept Videos
Linear Approximation in Frequency Domain
In contrast, nonlinear systems do not inherently possess these properties. However, for small deviations around an operating point, a nonlinear system can often be approximated as linear....
Linear Approximation in Time Domain
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length,...
Classification of Systems-I
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
First Order Systems
When a first-order system is subjected to a unit-step input, its response is characterized by its transfer function. By applying the Laplace transform of the unit-step input to the transfer function, expanding the...


