Entanglement-Enhanced Water Dissociation in Bipolar Membranes with 3D Electrospun Junction and Polymeric Catalyst

With the use of bipolar membranes (BPMs) in an expanding range of applications, there is an urgent need to understand and improve the catalytic performance of BPMs for water dissociation, as well as to increase their physical and chemical stability. In this regard, electrospinning BPMs with 2D and 3D junction structures have been suggested as a promising route to produce high-performance BPMs. In this work, we investigate the effect of entangling anion and cation exchange nanofibers at the junction of bipolar membranes on the water dissociation rate. In particular, we compare the performance of different tailor-made BPMs with a laminated 2D junction and a 3D electrospun entangled junction, while using the same type of anion and cation exchange polymers in a single/dual continuous electrospinning manufacturing method. The bipolar membrane with a 3D entangled junction shows an enhanced water dissociation rate as compared to the bipolar membrane with laminated 2D junction, as measured by the decreased bipolar membrane potential. Moreover, we investigate the use of a third polymer, that is, poly(4-vinylpyrrolidine) (P4VP), as a catalyst for water dissociation. This polymer confirmed that a 3D entangled junction BPM (with incorporated P4VP) gives a higher water dissociation rate than does a 2D laminated junction BPM with P4VP as the water dissociation catalyst. This work demonstrates that the entanglement of the anion exchange polymer with P4VP as the water dissociation catalyst in a 3D junction is promising to develop bipolar membranes with enhanced performance as compared to the conventionally laminated membranes.