Related Experiment Video
Updated: Nov 3, 2025

Experimental Procedure for Laboratory Studies of In Situ Burning : Flammability and Burning Efficiency of Crude Oil
Published on: May 1, 2018
Variations and characteristics of carbonaceous substances emitted from a heavy fuel oil ship engine under different
Fan Zhang1, Yingjun Chen2, Penghao Su3
1Key Lab of Geographic Information Science of the Ministry of Education, School of Geographic Sciences, East China Normal University, Shanghai, 210062, China.
Abstract:
Heavy fuel oil (HFO) accounts for approximately 80% of the fuel consumption of ocean-going ships in the world. Multiple toxic species are found in HFO exhaust, however, carbonaceous substances emitted from low-speed marine engine exhaust at different operating loads have not been thoroughly addressed. Therefore, a bench test for a low-speed marine engine with HFO fuel under different operating modes was carried out in this study. Emission factors and characteristics of CO2, CO, organic carbon (OC), elemental carbon (EC), as well as OC and EC fragments, organic matters of n-alkanes and polycyclic aromatic hydrocarbons (PAHs) are given and discussed. Combined with the correlation analysis results among the measured species and engine technical parameters, the formation processes and influence factors of carbonaceous components are also inferred in this study. Besides, together with OC to EC ratio, n-alkanes to PAHs ratio, etc., EC1 to soot-EC ratio in PM can be considered as tracer characteristic of high-sulfur-content HFO ship distinguished from diesel fuel ships. Profiles of n-alkanes and PAHs in PM can be used to distinguish shipping emission source from other combustion sources. Moreover, characteristics of carbonaceous components in size-segregated particles are also discussed, including OC, EC, OC and EC fragments, as well as organic matters. Results show that most of the particle mass, OC, EC, and organic matters are concentrated in fine particles with size of less than 1.1 μm, indicating the significance of ultrafine particles. Formation processes of OC and EC fragments, EC1 and soot-EC are also deduced and proved combined with the characteristics of OC and EC fragments, organic matters, and especially PAHs. Besides, the large variations of OC to EC ratios and speciated profiles of n-alkanes and PAHs in different particle size bins indicate that particle size should be considered when they are used as characteristic tracer in source apportionment studies.
More Related Videos
07:24Combustion Chemistry of Fuels: Quantitative Speciation Data Obtained from an Atmospheric High-temperature Flow Reactor with Coupled Molecular-beam Mass Spectrometer
Published on: February 19, 2018
08:16Combustion Characterization and Model Fuel Development for Micro-tubular Flame-assisted Fuel Cells
Published on: October 2, 2016
Related Concept Videos
Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified...
Enthalpy and Heat of Reaction
Turnover Number and Catalytic Efficiency
Chymotrypsin is a pancreatic enzyme that breaks down proteins during digestion....
Internal Combustion Engine
General External Flow Characteristics
Otto and Diesel Cycle