Related Experiment Video
Updated: Nov 3, 2025

Low-energy Cathodoluminescence for OxyNitride Phosphors
Published on: November 15, 2016
A novel M2Ga2GeO7:N3+(M = Ca, Ba, Sr; N = Cr, Nd, Er) sub-micron phosphor with multiband NIR emissions: preparation,
Zhihua Li1, Xin Ding1, Bing Yu1,2
1Institute of Biomedical Materials and Engineering, College of Chemistry and Chemical Engineering, College of Materials Science and Engineering, Qingdao University, Qingdao 266071, People's Republic of China.
Abstract:
Near-infrared (NIR) emission materials can be widely applied in various fields, such as food detection, imaging, treatment, electronic products. With the trend of miniaturization of equipment, smaller materials are needed. In this work, we successfully synthesized a series of M2Ga2GeO7:N3+(M = Ca, Ba, Sr; N = Cr, Nd, Er) samples and then focused on the study of Nd3+doped Sr2Ga2GeO7(SGGO). A series of SGGO:xNd3+sub-micron phosphors were prepared via a microwave-assisted sol-gel process combined with subsequent calcination at 750 ℃, and the structural information and luminescent properties were systematically studied. SGGO is a representative tetragonal crystal and belonging to the space group of P4¯21m (113). The Nd3+ions occupy eight-coordinated Sr2+sites in the crystal lattice. From SEM analysis, the average particle size distribution is 219.7 ± 41.4 nm. The sub-micron phosphors have rich excitation spectra ranging from 350 nm to 850 nm and can produce multiband NIR emissions of 1331, 1056, and 905 nm when excited by ultraviolet and NIR light. The maximum emission intensity was obtained by optimizing the doping ratio of Nd3+ions. A commercial chip was then utilized to fabricate light-emitting diodes (LEDs) to verify its application potential in NIR-II mini-LEDs. Compared with blue light LEDs, the as-prepared LEDs had good imaging penetration depth and could be clearly observed under 10 mm of chicken breast coverage. The maximum imaging penetration depth can be 33 mm.
More Related Videos
10:42In Depth Analyses of LEDs by a Combination of X-ray Computed Tomography CT and Light Microscopy LM Correlated with Scanning Electron Microscopy SEM
Published on: June 16, 2016
07:12Author Spotlight: Advancing Bioimaging and Therapy with Functional Nanomaterials
Published on: September 13, 2024