Development of a chitosan and hyaluronic acid hydrogel with potential for bioprinting utilization: A preliminary...

Bioprinting is a technique that has been applied in the areas of tissue engineering and regenerative medicine (TERM). Natural polymer-based hydrogels are known for their favorable biocompatible properties, as well as attractive biomaterials for cell encapsulation. These hydrogels provide an aqueous three-dimensional environment with biologically relevant chemical and physical signals, mimicking the natural environment of the extracellular matrix (ECM). Chitosan (CHI) and hyaluronic acid (HA) have been widely researched for biomedical applications. Bioinks are "ink" formulations, usually hydrogels, that allow the printing of living cells. This work proposes the development of a low cost and simple chitosan CHI-AH hydrogel with potential to become a bioink. At physiological temperature, the biomaterials form a hydrogel. The material developed was characterized by the analysis of morphology, cytotoxicity, and cell viability. FTIR showed the characteristic vibrational bands of chitosan and HA. No difference in swelling was observed between the different formulations studied, although SEM showed architectural differences between the hydrogels obtained. Extract cytotoxicity testing showed that the hydrogel is not cytotoxic. The direct toxicity test also revealed the absence of toxicity, but the cells had difficulty migrating into the gel, probably because of its density. These data were confirmed by SEM. Further testing are ongoing to better understand the gel's characteristics to improve the limitations found so far.